Validating a checked box and then running code

by cre8tivspirit at 2013-03-13 07:24:29

Hey All,
I’m a fairly new Powershell script developer and I’m trying to figure out how to use check boxes. I am responsible for the installation of a lot of software at my company and I have a script that will run through and install it all. This is great for a new workstation setup but sometimes I only need to install some of the software. I have a form coded with a partial list of the software but I’m not sure how to proceed once the boxes are checked and the “OK” button is pressed. I’ve attached to form code so you can see where I am so far. Any suggestions on cleaning up the forms code would be appreciated as well. Thanks in advance.
by DonJ at 2013-03-13 08:11:31
In terms of help for GUI, we have a forum here that’ll link you off to SAPIEN technologies - they’ve volunteered to field those questions as they deal with the technology a lot.